64670-21 Reliance Current Transducer

2) Ladder Bar Weldments 2) Rear Housing Brackets
4) RH Solid Rod Ends 6) RH Jam Nuts
2) Spherical Rod Ends 8) Washers
2) 3/4"-16 x 2-1/2" Bolts 2) 3/4"-16 Nylock Nuts
4) 3/8"-16 x 1" Bolts 4) 3/8"-16 Locknuts
2) Front Housing Brackets 2) Safety Straps

Read all Instructions completely before beginning the installation. The following suggestions will help to
ensure a quality installation.
- Welding should be done using either the MIG or TIG process. A welding machine rated at 130 amps
or higher should be used to ensure adequate penetration.
- Do not install this kit with the rear suspension extended. Set the car at ride height and leave it there
for the duration of the project.
- Tack weld everything and double-check all your measurements before final welding.
- Remove the axles and axle bearings before welding on the housing to prevent damage.
- Leaf spring equipped vehicles require a housing floater to eliminate bind. We recommend using
Competition Engineering's C2030 bolt-on floater mount kit.
- Coil spring equipped vehicles require a diagonal link or panhard bar to keep the rear centered in the
car. Competition Engineering offers P/N: C2052 Bolt-on Diagonal Link and P/N: C2037 Panhard Bar
to suit your needs.